Inhaltsverzeichnis
Werbung
Instructions for Use
Startup and Operation of the TwisTorr 305 FSQ & 305
SF
To turn on the TwisTorr 305 FSQ & 305 SF via the on board controllers or the
remote controllers, connect the pump to the controller, supply the controller with
the proper supply voltage and then act on the "START" and "INTERLOCK" signals
(which are located on the controller's interface).
Once these signals are recognized the controller will start the pump.
Please refer to the controller's relevant instruction manuals in order to:
NOTES
1
2
3
X3507-64130
X3507-64131
X3506-64130
X3506-64131
The initial startup of the pump will be in "SOFT START" mode; for detailed
WARNING
information on this mode refer to the dedicated section on page 178.
Agilent TwisTorr 305 FSQ & 305 SF User Manual
Find the location of the power supply inlet as well as the mains input voltage
admitted values (Remote: Chapter Technical Information; On Board: Chapter
Technical Information).
Find the location of the START/STOP and INTERLOCK input pins as well as
the related electrical ratings (Remote: Chapter Technical Information; On
Board: Chapter Technical Information).
Find details about how to connect the START/STOP and the INTERLOCK
signals (Remote: Chapter Technical Information; On Board: Chapter
Technical Information).
Controller MPNs
Twistorr 305 FS onboard 24V
Twistorr 305 FS onboard 110/230V
Twistorr 305 FS AG Remote RS232/485
Twistorr 305 FS AG Remote Profibus
Controller Descritpion
Ref.Instruction
Manual
87-901-060-01
87-901-060-01
87-901-059-01
87-901-059-01
175
Werbung
Inhaltsverzeichnis
