Getting Started - Dymo LM100+ Bedienungsanleitung

LM100 + N-EU.qxd 14-09-2001 14:09 Pagina 103
How to use your DYMO
LabelMANAGER 100+
What LabelMANAGER 100+
can do for you
With the DYMO LabelMANAGER 100+ you
can create a wide variety of high-quality
self-adhesive labels. You can choose to
print them in a range of different sizes and
styles. The LabelMANAGER 100+ can print
on 6mm ( "), 9mm ( ") or 12mm ( ")
1/4 3/8 1/2
width. DYMO tape cassettes are available in
a wide range of colours: tape is back-slit for
easy removal from the backing tape.
Warranty Registration
Please complete the warranty registration
card and return it to the relevant customer
service address, within seven days– see the
warranty booklet for details.

Getting started

STEP ONE - insert the batteries
• Apply pressure to thumb catch and open
hinged access door – see fig A, page 2.
• Insert six size AA alkaline batteries, observing
the polarity markings A1, and close cover.
• Remove batteries if the LabelMANAGER
100+ is to remain unused for some time.
AC ADAPTOR (optional)
• Connect the AC adaptor to socket B1.
Inserting the adaptor plug disconnects the
supply from the batteries.
• Unplug the AC adaptor from the
LabelMANAGER 100+ before disconnec-
ting the mains power to the adaptor,
otherwise last label memory settings will
be lost (see also ON/OFF).
STEP TWO - insert the cassette
• Press catch in and open hinged access door.
• Ensure tape and ribbon B3 are taut across
mouth of cassette and tape passes between
guideposts before installing as shown.
If necessary, turn spool B4 clockwise to
tighten ribbon.
• Check that cassette switch D4 is set for
the cassette type – see page 2. A notch in
the cassette will fit over the switch when
it is set correctly.
• Insert cassette with tape and ribbon
positioned as shown between print head C1
and pinch roller C2.
• Push firmly C3 until cassette clicks into place.
Ensure tape and ribbon are positioned
correctly.
• Close door B5 until it clicks shut.
3