Care And Cleaning - Kenwood SJM160 Serie Bedienungsanleitung

key
spout
finger pad
flip top lid
lid release button
water level windows
on/off switch with indicator light
360° powerbase
cord wrap
filter
a clips
b compartment
c central divider
d bypass
to use your kettle
1 Fill the kettle through either the
spout or lid. To open the lid, press
the lid release button. The water
level must be between 'MAX' and
1 cup (200-250mls).
Be economical: do not boil more
●
water than you need.
To improve the quality of your drinks
●
always use fresh water.
Empty the kettle after each use.
●
2 Check the lid is closed. Close the lid
by pushing down on the finger pad
area .
3 Plug in and switch on. The indicator
light will come on.
4 Your kettle will boil and switch off
automatically. To re-boil, wait a few
seconds - the on/off switch needs
time to reset.
If you experience problems
●
with your kettle switching on
and off during use or
switching off before boiling,
check that the flat element is
free from scale - see
"descaling".
Your kettle is fitted with a filter to
●
hold back limescale particles.
If you find drops of water under your
●
kettle, don't worry - it is just
condensation.
boil-dry protection
If you switch on with too little water,
●
your kettle will cut out automatically.
Switch off, remove from the
powerbase and let it cool down
before re-filling. When it has cooled
down, the switch will reset itself.
using the kettle with the
1 Ensure the
into place correctly.
2 Pour the water into the
compartment
top of the central divider
cup measure. Adjust your fill rate to
match your required cup measure.
If the
●
to measure more than 1 or 2 cups,
pour the water directly into the
bypass opening

care and cleaning

Before cleaning, unplug your kettle
●
and let it cool down.
the outside and powerbase
Wipe with a damp cloth, then dry.
●
Do not use abrasives - they will
scratch the metal and plastic
surfaces.
the inside
Even though your kettle comes with
●
a filter, you still need to clean the
inside (and the filter) regularly.
Lift the
●
divider .
Wash in warm soapy water, dry and
●
refit by clipping back into position.
the filter
1 Open the lid.
2 Slide the filter out
3 either rinse under the tap or use a
soft brush.
or when descaling your kettle, drop
the filter in too. Rinse thoroughly.
4 Slide the filter back in to refit.
3
is clipped
until level with the
for a 1
is fitted and you wish
.
out using the central
.