Filling With Coffee Powder; Pressing The Coffee Powder; Brewing Coffee; After Preparation Of Coffee/Espresso - Jura SUBITO Bedienungsanleitung

Bed.subito d/F/I/E/SP/NL 22.10.2001

6.2 Filling with coffee powder

● Rotate the cover to the "Fill coffee" position (Fig. 1).
● Put a maximum of two level tablespoons of coffee powder
in the filler funnel. The strength of the coffee depends on
how much coffee is used.
Important: Only use ground coffee powder. Never fill the
funnel with coffee beans or instant coffee.

6.3 Pressing the coffee powder

● Rotate the cover a 1/4 turn further to the "Brewing" posi-
tion (Fig. 2).
● Pull out the release lever and press the crank handle firmly
downwards without forcing it until you feel it reach the stop
position (Fig. 3). Let go of the release lever. The coffee
powder is now pressed.
● Ensure that the crank handle is securely located in the
lowered position. To do this, pull the ball on the crank
handle lightly upwards.

6.4 Brewing coffee

● Place one or two cups beneath the adjustable coffee spout.
● Check that the selector switch is in the coffee position (
● Turn on the operating switch (
4). Due to the build-up of the brewing pressure, the cover
may lift up slightly.
● Once the required amount of coffee has been brewed, turn
off the operating switch (
Note: While coffee is being drawn off, the heater warning
lamp ( ) may light up. This shows that the system is
heating. The brewing process must not be interrupted.
17:39 Uhr Seite 39
).
) and draw off coffee (Fig.
) again.

6.5 After preparation of coffee/espresso

● Release the crank handle and lift it up (Fig. 5).
● Rotate the cover back to its basic position, i.e. a 3/4 turn
(Fig. 6).
● When the cover is rotated, the coffee grounds are automati-
cally ejected into the grounds container. The machine is
ready for use again.

7. Drawing off water

● Fill the water tank with fresh tap water (no further than the
mark) and replace it in the machine, ensuring that it clicks
home correctly.
● Now turn on the power switch ( ). When the heater
warning lamp ( ) goes out, the machine is ready for use.
● Place a cup under the water nozzle and turn the selector
switch to the water position (
● Turn on the operating switch (
Attention: Hot water can cause scalding.
● Once the required amount of water has been draw off, turn
off the operating switch again (
switch back to the coffee position (
Note: While water is being drawn off, the heater warning
lamp ( ) may light up. This shows that the system is
heating. The process must not be interrupted.
).
) and draw off water.
) and turn the selector
).
39
E