Kenwood KMR-M308BTE Bedienungsanleitung Seite 17

Symptom Remedy
"iPod ERROR" appears. Reconnect the iPod. / Reset the iPod.
"READING" keeps flashing. Do not use too many hierarchical levels or folders.
Elapsed playing time is not This is caused by how the tracks are recorded.
correct.
Correct characters are not This unit can only display uppercase letters, numbers,
displayed (e.g. album name). and a limited number of symbols. Uppercase Cyrillic
letters can also be displayed if [RUSSIAN SET] is set to
[РУССКИЙ BКЛ]. ( 4)
No Bluetooth device • Search from the Bluetooth device again.
is detected. • Reset the unit. ( 3)
Pairing cannot be • Make sure you have entered the same PIN code to both
made. the unit and Bluetooth device.
• Delete pairing information from both the unit and the
Bluetooth device, then perform pairing again. ( 8)
"DEVICE FULL" The number of registered devices has reached its limit.
appears. Retry after deleting an unnecessary device. ( 11,
DEVICE DELETE)
Echo or noise occurs. • Adjust the microphone unit's position. ( 8)
• Check the [ECHO CANCEL] setting. ( 9)
Phone sound quality • Reduce the distance between the unit and the Bluetooth
is poor. device.
• Move the car to a place where you can get a better signal
reception.
• Voice calling method • Use voice calling method in a more quiet environment.
is not successful. • Reduce the distance from the microphone when you
• "N/A VOICE TAG" speak the name.
appears. • Make sure the same voice as the registered voice tag is
used.
Symptom Remedy
"NOT SUPPORT" The connected phone does not support Voice
appears. Recognition feature.
• "NO ENTRY" appears. There is no registered device connected/found via
• "NO PAIR" appears. Bluetooth.
"ERROR" appears. Try the operation again. If "ERROR" appears again,
check if the device supports the function you have
tried.
"NO INFO" appears. Bluetooth device cannot get the contact information.
Sound is being • Reduce the distance between the unit and the
interrupted or skipped Bluetooth audio player.
during playback of a • Turn off, then turn on the unit and try to connect again.
Bluetooth audio player. • Other Bluetooth devices might be trying to connect to
the unit.
The connected • Check whether the connected Bluetooth audio player
Bluetooth audio player supports Audio/Video Remote Control Profile (AVRCP).
cannot be controlled. (Refer to the instructions of your audio player.)
• Disconnect and connect the Bluetooth player again.
• "HF ERROR XX" Reset the unit and try the operation again. If this does
appears. not solve the problem, consult your nearest service
• "BT ERROR" appears. center.
TROUBLESHOOTING
ENGLISH | 15