AFRISO WWG Betriebsanleitung Seite 35

2.2 Intended use
The product may only be used to detect conductive liquids and only to mon-
itor:
• Pipes for leakage
• Water ingress from the outside
• For early indication of water damage
• Leaks, backflow or flooding
• Collection facilities below devices consuming water
• Manholes, pipe and cable ducts
• Storage and transport of conductive liquids
The product may only be used for the following liquids at atmospheric pres-
sure:
• Grey water
• Mains water, fresh water
• Aqueous solutions such as beverages, acids, bases
• Antifreeze agents, liquid fertilisers
• Conductive water mixtures, emulsions
The product is suitable for conductive liquids to which the following wetted
parts are sufficiently resistant:
• Electrodes: V2A
• Plastic: PA, PP
• Sealing material: Polyolefin base
• Cable: Ölflex
Any use other than the application explicitly permitted in these operating
instructions is not permitted and causes hazards.
Verify that the product is suitable for the application planned by you prior to
using the product. In doing so, take into account at least the following:
• All directives, standards and safety regulations applicable at the installa-
tion site of the product
• All conditions and data specified for the product
• The conditions of the planned application
Information on safety
EN
WWG
4