Operating Instructions; Operating The Tool - Signode JOSEF KIHLBERG JK1219HT Betriebsanleitung

Josef Kihlberg JK1219HT
5

5.1 OPERATING THE TOOL

– Check that the tool is adjusted to the right strap size
adjust if needed (see chapter 6.4).
– Wind strap tightly round packed goods, so that the
straps lie above each other on top. Hold the strap in
the left hand so that the lower strap start (Fig.3) is
approx. 20 cm (8") from the hand.
– Hold the tool in right hand and raise rocker lever
(3/1) against sealing lever (3/2).
– Place the tool against the strap until this contacts
the stop. The lower strap start projects approx.
5 cm (2") above the tool.
– Release rocker lever. The straps are clamped
tightly and are fed from the tool.
If the straps are not inserted correctly in
the tool, it is not possible to perform the
tensioning operation.
Before tensioning ensure that no other
persons are in the danger area!
– Hold the sealing lever (Fig. 4/1) in the left hand and
with the right hand move the tensioning lever (4/2)
backwards and forwards until the required strap
tension is obtained.
6

OPERATING INSTRUCTIONS

Fig. 3
Fig. 4
2
2
05.20