Installation On A Wall Using A Screw / Peg; Adjusting The Motion Sensor - Parkside PTUS 1 A1 Bedienungs- Und Sicherheitshinweise

Point the product, so that the motion sensor
wards the area you wish to monitor. Make sure that the area
you wish to monitor is not blocked by objects, such as trees or
garden furniture.

Installation on a wall using a screw / peg

Use the enclosed peg
the product on a wall. This installation material is intended for a
normal wall. If the wall you wish to install the product on has a
different consistency, check with a specialist to find out which
material is suitable for installation on your wall.
Ensure the screw
Allow the screw to protrude approx. 1 cm from the wall and
use the loop
Operation
The product has two adjustment options:

Adjusting the motion sensor

The sensitivity of the sensor can be adjusted using the sensitivity
controller . If a movement is detected, a signal / flash sounds /
2
shines approx. 30 sec. Adjust to MAX position, the detection range
approx. 8 m.
76 GB/MT
(Ø 6 mm) and the screw
18
is a maximum of 1.5 m above the ground.
17
to hang the product on the screw.
7
is pointed to-
5
to install
17