Lanaform WBPM-110 Bedienungsanleitung Seite 12

PROBLEM POSSIBLE CAUSE SOLUTION
LCD Pneumatic sys-
shows "ER 3" tem blocked
during inflation
LCD Pneumatic sys-
shows "ER 4" tem leakage
during inflation
Troubleshooting (2-2)
PROBLEM POSSIBLE CAUSE SOLUTION
LCD Cuff pressure
shows "ER 5" above 300mmHg
LCD More than 160
shows "ER 6" seconds with
cuff pressure
above 15 mmHg
LCD Inner Mem-
shows "ER 7" ory error
LCD Device parame-
shows "ER 8" ter checking error
LCD Pressure sensor
shows "ER A" parameter error
No repsonse Incorrect oper-
when you ation or strong
press button or electromagnet-
load battery ic interference
10. Maintenance
01 Do not drop this monitor or subject it to
strong impact.
02 Avoid high temperature and solarization. Do
not immerse the monitor in water as this will
result in damage to the monitor.
03 If this monitor is stored near freezing, allow it
to acclimate to room temperature before use.
12 · 202104LA090207003 · 09/02/21
04
Connect the cuff
correctly and
try again. If the
monitor is still
05 The monitor requires 6 hours to cool from the
abnormal, please
contact the lo-
cal distributor
or the factory
06
07 If you do not use the monitor for a long time,
08 It is recommended the performance should be
Measure again
after five min-
utes. If the
09 Clean the monitor with a dry, soft cloth or a soft
monitor is still
abnormal, please
contact the lo-
cal distributor
10 No component can be maintained by user in the
or the factory
Take out bat-
teries for five 11 The monitor can maintain the safety and perfor-
minutes, and
then reinstall
all batteries
12 It is recommended the cuff should be disinfect-
13 Not servicing/maintenance while the mon-
The monitor requires 6 hours to warm from
the minimum storage temperature between
uses until the monitor is ready for its INTEND-
ED USE when the ambient temperature is 20°C.
maximum storage temperature between uses
until the the monitor is ready for its INTEND-
ED USE when the ambient temperature is 20°C.
Do not attempt to disassemble this monitor.
please remove the batteries.
checked every 2 years or after repair. Please
contact the service center.
cloth squeezed well after moistened with water,
diluted disinfectant alcohol, or diluted detergent.
monitor. The circuit diagrams, component part
lists, descriptions, calibration instructions, or
other information which will assist the user's
appropriately qualified technical personnel to
repair those parts of equipment which are des-
ignated repairably can be supplied.
mance characteristics for a minimum of 10,000
measurements or three years, and the cuff in-
tegrity is maintained after 1,000 open–close
cycles of the closure.
ed 2 times every week if needed (For example, in
hospital or in clinique). Wipe the inner side (the
side contacts skin) of the cuff by a soft cloth
squeezed after moistened with Ethyl alcohol
(75-90%), then dry the cuff by airing.
itor is in use.