Battery Replacement; Tips For Troubleshooting; Tecnical Data - Abus HomeTec Pro CFA3100 Anleitung

Battery replacement

6.
6.1a
aprox. 3 sec. - 10 sec.
+
AA
-
6.1c
6.1d
B
A
2.
1.
30
6.1b
B
A
2.
3.
Replace all the batteries!
First remove the four batteries and
then insert four new batteries / accus
"ready to use".
ready
+ +
to
AA
use
4x
6.1e
automatic calibration run
-
6.1 b 6.1 d

Tips for troubleshooting

7.
Fault / information
After the teach-in
process, the LEDs
flash during the
first locking
process and a
sustained acoustic
1.
signal sounds
The LEDs flash
during normal
service and a
sustained acoustic
signal sounds
An acoustic signal
sounds before
every rotational
movement by the
drive
Before opening the
door, the drive
carries out a refe-
rence movement

Tecnical data

8.
Dimensions
Weight (without batteries)
IP class
Battery type
Operating temperature range
Radio frequency
Max. radiated transmission power
Encryption
Cause Solution
The door was not closed Repeat the teach-in
during the second part process and close the
of the teach-in process door at the specified
time
- The door is not closed - Close the door and
during operation so repeat operation
the drive pushes the
door bolt against the
door edge
or
- at least one battery is - open the battery
inserted the wrong compartment and
way round check the polarity of
the batteries/insert
or the batteries correctly
- the locking mechanism >> 6.
is stiff or the door is - set the door correctly
calibrated incorrectly Lubricate the locking
mechanism
The batteries are dead Change the batteries
>> 6.
The door has since been No action is required.
manually opened/closed A reference movement is
using a key or the drive's necessary to identify the
handwheel has been correct position after the
turned drive has been manually
turned using a key from
outside or the hand-
wheel from inside.
138 x 52 x 65 mm
418 grams
IP 20
4 * AA 1,5 V alkaline
0°C to +40°C
2,402 GHz - 2,480 GHz
< 10dBm eirp
AES-128-Bit
31