ABS AVALANCHE AIRBAG SYSTEM Gebrauchsanleitung Seite 29

Step 5
Attaching activation handle
In order to attach the activation handle, align the pin with the
brass coupler and push the handle in. With the other hand flip
up the plastic flap, thus administering counter pressure.
The brass coupler will automatically snap back.
Attention! Only attach the handle if a full cartridge has been
screwed in. When activating without a cartridge or with an empty
one, the system will be damaged and the pin must be exchanged.
Please direct all inquires to your respective Service center.
If you followed all the steps up to this point your ABS-System
is now operational. However, we recommend that you finish
studying the instruction manual before you conduct your practice
activation.
Step 6
Velcro closure
The Velcro closure secures the activation handle in order to avoid
unwanted activations. Before you leave a patrolled area, the
red Velcro closure must be completely loosened and attached
behind the activation handle to facilitate an unhindered activa-
tion. A tightly fastened Velcro usually prohibits an activation.
Only then is the handle
attached properly and
ready to use. If the
handle will not attach
refer to point 12.1.
If the handle is not
attached properly and
is stuck due to the
coupler snapping back
into place, a proper
activation will be
impossible.
In order to completely eliminate unwanted activations we
recommend that you remove the activation handle. Particularly
in situations when you could endanger yourself and other people
such as on chairlifts, in gondolas, in or around a helicopter, the
bus, train, automobile, etc.
For the wireless activation handle please consult the special
instruction manual.
English
25