Pre-riding inspection
To ensure safe riding, please perform the following
inspection before operation of unit.
Inspection of front and rear brake
The free play of front brake lever is10-20mm. The
free play of rear brake lever is 10-20mm.
'Free Play' is defined as range of travel before enga-
gement of brakes. Lever/pedal should move freely
throughout entire range of travel.
Brake fluid
What this vehicle uses is DOT3 or the DOT4 brake fluid. It cannot use
the remaining fluid of the opened cylinder or the brake fluid of previous
repair. The old fluid can absorb the moisture in the air. Pay attention to
break fluid; do not let the fluid splash to paint surface or plastic surface,
as it will erode the surface of these substances. Attention to check brake
fluid storage tank of liquid, if the brake fluid drop to lower limit ,adding
the brake fluid to the specified limit to the upper limit will be required.
When the brake pads old, the memory fluid of the cylinder pours into the
pressure pipe automatically, while the fluid drops along with it.
Brake pad
Check the brake pads whether wear to the limit nick or not. If reach
to the limit nick, should replace it in time to maintain the best braking
performance. If the braking system or brake pads need to repair, we
strongly advise you leave the work done by the distribution. Disc brake
system is a high-pressure brake. For security, hydraulic tube should be
replaced once every four years; the brake fluid should be replaced every two years.Do not drive immedi-
ately, when the brake pad just replaced. Pick-and-place brake pads several times to recover the normal
extension of the hold hands, and brake fluid cycle stably. At the same time, controls brake in low speed to
make it meet the requirement.
14
1-2cm
1-2cm
MIN
INDICATOR