Extend The Cable; Working With The Cable Ø 8 Mm / Adapter; Drain Cleaning - Wohler Rm 300 Bedienungsanleitung

Operation
6.2

Extend the cable

Fig. 10: Release guide hose, locking bolt
marked by an arrow
6.3 Working with the cable
Ø 8 mm / adapter
Fig. 11: Adapter attached to the RM 300
6.4

Drain cleaning

32
If you want to extend the cable, pull the end
•
out of the guide hose.
To do so, pull up the locking bolt on the shaft
•
entrance and pull off the guide hose.
Connect the next cable piece and push the
•
entire cable length back into the guide hose.
Use adapter with the 8 mm or 10 mm cable, 5 m
length, for narrow pipes or pipe bends.
• To do so, pull the cable approx. 30 cm out of
the adapter magazine and push it through the
shaft.
Push the adapter magazine into the shaft
•
entrance and lock it with the bolt.
ATTENTION!
Due to the lower stiffness of the 8 mm cable, it
should never be used in large pipes or with hard
obstacles.
• Position the machine max. 50 cm in front of
the opening of the pipeline you wish to clean.
Ensure that the stand is firm.
WARNING!
Take care that the Wöhler RM 300 and the mains
cable are not placed in water.