KlimaDeluxe 7000 BTU Bedienungsanleitung Seite 9

unless the components are constructed of materials which are inherently resistant to being
corroded or are suitably protected against being corroded.
Checking electrical devices
Repair and maintenance of electrical components shall include initial safety checks and
component inspection procedures. If a fault exists that could compromise safety, then no
electrical supply shall be connected to the circuit until it is satisfactorily dealt with. If the fault
cannot be corrected immediately, but it is necessary to continue operation, an adequate
temporary solution shall be used. This shall be reported to the owner of the equipment, so
all parties are informed.
Initial safety checks shall include:
- The capacitors are discharged: this shall be done in a safe manner to avoid possibility of
sparking.
- That no live electrical components and wiring are exposed while charging, recovering or
purging the system.
- That there is continuity of earth bonding.
WARNING!
- Install the device in rooms which exceed 7 m².
- Do not install the device in a place where inflammable gas may leak.
NOTE!
The manufacturer may provide other suitable examples or may provide additional
information about the refrigerant odour.
3) INSTALLING AND USING THE DEVICE
First use
Open the packaging carefully before taking out the device. Make sure the device is
complete and undamaged. If any components are missing or damaged, contact the vendor
and do not use the product. Retain the packaging or recycle it in accordance with local
regulations.
• Remove all packaging from the device.
• Clean the device with a damp cloth. Please refer to the 'cleaning
and maintenance' section.
• Continue with the procedure in the 'using the device' section.
Using the device
Place the device on a firm and solid surface, in an area with at least 50 cm of free space
around the device, generating a proper air circulation.
Do not operate the device close to walls, curtains or other objects
3 2
that might block the air inlets and air outlet , resulting in a
bad air circulation.
WARNING! If the device has a slanted position of more than
45°, allow it to stand upright for at least 24 hours before use.
Ensure that the device does not come into contact with heat sources, such as radiators, hot
hobs or naked flames.
Make sure the device is not exposed to direct sunlight.
Install the device in rooms of more than 7m2
EN 07