Troubleshooting - KlimaDeluxe 7000 BTU Bedienungsanleitung

Cleaning the device
• Never use aggressive or abrasive cleaning materials, cleaning alcohol or sharp objects
like hard brushes or knives.
• Clean the exterior of the casing with a damp cloth.
• Then dry the exterior with a dry cloth.
Note:
• The device CANNOT be immersed in water.

5) TROUBLESHOOTING

Symptom
√ Check the plug connection.
The device is √ Check if the water level indicator lights
up.
not operating
√ Check the room temperature.
√ Check the air filters for dirt.
√ Check if the air exhaust is blocked.
√ Check if the room temperature is too low
or too high.
The device
does not
√ The exhaust hose is detached.
cool as set
√ Set temperature is higher / lower than
current temperature.
√ Overflow while moving the device.
Water
√ Check if the drain hose is kinked or bent. Straighten the drain hose to
leakage
√ Check if the device is securely positioned. Place the device on a horizontal
Excessive
√ Check for any loose or vibrating parts.
noise
√ Noise sounds like water flowing.
√ Communication faults between the
E0
device main PCB and display.
√ Temperature sensor failure
E1
Error
√ Humidity sensor dampened or failure.
E2
codes
√ Condensate water high level alarm.
Ft
Inspection
EN 14
Solution
Insert the power plug securely
into the power socket.
Empty the water tank (drainage)
and reinstall correctly.
The range of operating
temperature is 5 - 35°C.
Clean the air filter.
Clear it from any obstacles.
This is normal. Allow more
time for cooling down when the
device is first turned on.
Make sure the exhaust hose is
securely attached.
Set the temperature at proper
set-point according to the
manual.
Empty the water tank (drainage)
before transport.
avoid the creation of a trap.
and firm surface.
Secure and tighten the parts.
Noise comes from flowing
refrigerant. This is normal.
Contact the reseller.
Contact the reseller.
Contact the reseller.
Empty the drain pan by
removing the rubber plug from
the drain opening.