KlimaDeluxe 7000 BTU Bedienungsanleitung Seite 13

Dehumidifying mode
Press the mode button on the device
on the digital control panel lights up.
3
In this mode, the FAN speed cannot be selected and will be in the default low speed
setting.
Note!
In dehumidifying mode, the drain hose
opening to release the condensed water.
7
See "Drainage" for connection instructions.
Sleep mode
The sleep mode can only be activated in cooling mode.
After 1 hour the preset temperature is increased by 1°C after another hour the preset
temperature will again be increased by 1 °C (maximum 2 degrees increase).
The sleep mode can only be activated by pressing the Sleep button
control. The display
brightly when sleep mode is activated.
Press the sleep mode button again to deactivate the sleep mode, the power LED indicator
& display will light up brightly when the sleep function is deactivated.
Timer setting
The timer settings can be set from 1 hour to 24 hours.
There are 2 timer modes, to turn the device OFF and to turn it ON.
Timer turn OFF (when power is ON)
• Press the TIMER button on the device
digital control panel lights up 00.
• To set the timer delay OFF, press the increase
press the increase
or decreases by one hour. The selected time is indicated on the display
Timer turn ON (when power is OFF)
• Press the TIMER button on the device
digital control panel lights up 00.
• To set the timer delay OFF, press the increase
press the increase
or decreases by one hour. The selected time is indicated on the display
Cancelling the set timer
To cancel the timer, press the increase
B
increase or decrease
Automatic defrost
At a low room temperature, frost may build up at the evaporator during operation.
The device automatically starts defrosting, the POWER LED
& power LED indicator
8
B C
or decrease
B C
or decrease
C
button on the remote control, until OO shows on the display
or remote control
2
F
needs to be connected to the drain
on the digital control panel will shine less
1
or remote control
6
or decrease
4
button on the remote control. Each press increases
or remote control
6
or decrease
4
button on the remote control. Each press increases
or decrease
4
EN 11
H
until the DRY LED indicator
J on the remote
D until the display
button on the device or
9
8
D until the display
button on the device or
9
8
button on the device or press the
9
starts blinking.
1
on the
8
.
on the
8
.
.
8