Special Safety Instructions; Preparations For Assembly; Assembly And Preparation - inshape FB500S Gebrauchsanweisung

When the equipment is in use, it should
be monitored continuously. When the
equipment is in use, any children near it must
not be left unattended. The equipment is not
a toy.
Remember to check the equipment
regularly. Tighten all screws, bolts and nuts
on the equipment as required. Inspect the
equipment and replace any worn parts. Do
not use the equipment if it is defective.
When moving the equipment, employ the
correct lifting technique.
The equipment is only intended for indoor
use in private households.

Special safety instructions

WARNING! The pulse monitor may be
inaccurate. Training too hard may involve a
risk of personal injury or death. If you feel
unwell, stop exercising immediately.

Preparations for assembly

Two people are required to assemble the
equipment.
Lay all the pieces out on the � oor and check
that all the parts are there.
Please refer to the illustration and parts list at
the back of the manual.
Use the tools provided for assembly.

Assembly and preparation

Step 1
Screw the front stabiliser (31) and the rear
stabiliser (48) securely to the frame (29) using
the bolts (32), curved washers (17) and cap
nuts (33).
Attach the left pedal (34L) to the left pedal
crank by screwing it anti-clockwise.
Attach the right pedal (34R) to the right
pedal crank by screwing it clockwise.
Step 2
Connect the sensor cables (14, 26).
Insert the end of the tension cable (16) into
the � tting (27) as illustrated.
Insert the handlebar post (13) down into the
socket on the frame (29) and secure with
bolts (18) and curved washers (17).
GB
27