Caframo Compact Digital Anleitung Seite 16

Clockwise Mixing
Turn the stirrer on by pressing the power button. The display will read 40 rpm (or
last set speed when Auto Start is enabled) and the speed LED dot will be illumin-
ated. Increase to the desired speed and press the start/pause button. The stirrer
will start turning in a clockwise direction. The speed LED dot will be illuminated
(solid) and the speed value in rpm will be displayed.
Counter Clockwise Mixing
Set by following the clockwise stirring instructions above. Press the reverse but-
ton. The reverse button can be pressed while the stirrer is running to mix in a
counter clockwise direction. The LED dot above the reversing icon will be illumin-
ated (solid) when mixing in a counter clockwise direction.
Countdown Timer
Turn the stirrer on by pressing the power button. Set the desired speed by press-
ing the "+" button. Press the multifunction button until the LED dot for time is
illuminated. Press the "+" to set the countdown timer in minutes. Press the start/
pause button to start mixing. Press the multifunction button to toggle the display
between speed, time and cycle. Stirring stops when time is completed. Three
beeps will sound. Note: Countdown Timer value cannot be changed during oper-
ation.
xRx Agitation Cycle
Turn the stirrer on by pressing the power button. Set speed as above and count-
down timer if desired. Press the multifunction button once more until the indica-
tor light for cycle is illuminated. Press the "+" to set the number of seconds the
impeller will rotate in one direction before changing directions. Press the start/
pause button. Note: xRx Agitation Cycle value cannot be changed during oper-
ation.
For example: If set for 5 seconds the impeller will turn clockwise for 5 seconds
at the set speed then stop and change to turn counter clockwise for 5 seconds.
This pattern will continue until the pause button is pressed or until the time is
completed (if set).
The display will show the cycle seconds counting down during each direction
unless speed or the countdown timer is selected.
When the stirrer is powered on, the default speed is 40 rpm, countdown timer is
0 minutes, and the xRx agitation cycle is 0 seconds. Previously set values will be
displayed if Auto Start is enabled.
The stirrer will remember the original values set for speed, the countdown timer
and the xRx agitation cycle so that when the start/pause button is pressed again
the operations will repeat.
Speed can be changed (increased or decreased) while the stirrer is running. Press
14