Saftey Information; Symbols/Warnings; Organizational Measures; Informal Safety Measures - Hammerbacher VXDKB Serie Betriebsanleitung

Safety information

Symbols/warnings

The Operating manual uses the following terms and signs to indicate dangers:
This symbol indicates an immediate threatening situation for any person's life or
health. Failure to adhere to such information may have serious consequences for
health, or could even result in life-threatening injury or death.

This symbol indicates important information. Failure to adhere to such
information could lead to damage to the workstation.
Do not place objects or parts of the body under the workstation frame or between
the cross members. This could cause serious injury or even result in death.
Do not exceed the maximum permitted load on the workstation frame.
max . 80 kg
Overloading could lead to breakage and serious injury as a consequence.
This symbol warns of dangerous electrical voltage.

Organizational measures

• The workstation frame can best be assembled by two people. Turning the frame, once the work surface
has been fitted, is a task in particular which requires two people!

Informal safety measures

• Keep the assembly/operating manual in the place where the workstation frame is used at all times.

Note for those assembling the workstation

• The workstation must be assembled/worked on by persons over the age of 16.
• The persons referred to above must have read and understood the assembly/operating manual.

Transport and assembly

• The workstation frame must only be moved when it is disconnected from mains electricity (i.e. when the
plug has been removed from the socket).
• The workstation frame must be moved by two persons only, and in such cases must be retracted.
• Do not drag or pull the workstation frame over the floor.
• You need a Phillips screwdriver for mounting.
• Assemble the workstation table with the supplied Allen key. They are the only tools which ensure that
the Allen screws can be tightened to the correct torque.

Safety/protective measures

• Replace the drives if the circuit breaker in the drives fails.
• Faulty circuit breakers will not switch off the drive in the top/ bottom setting. In such cases, the
workstation frame has been taken to the mechanical stop and can no longer be raised/lowered.
• Do not allow children to use the workstation frame unsuper vised.
• Please make sure that further adjustment is impossible when the frame is still used by children.
6
VXDKB EN