General; Local Value Of The Assembly/Operating Manual; Intended Use; Improper Use - Hammerbacher VXDKB Serie Betriebsanleitung

General

Local value of the assembly/operating manual

The guiding principle for safe use and trouble-free operation of this workstation is knowledge of basic safety
information and regulations.
This assembly/operating manual contains the most important information needed for assembling and
operating the workstation frame safely.
This assembly/operating manual, in particular the safety information contained herein, must be observed
by any person building the frame and working on the finished surface. More importantly, the rules and
regulations applying to accident prevention in the locality in the workstation frame is to be used must be
observed at all times.

Intended use

The table must be used only as an electrically height-adjustable workstation for sitting/standing use in offi
ces or other enclosed areas. The table must be used for this purpose only. Any other use than the above
shall be deemed improper. Please observe the provisions of Section "Safety Information". Children may be
unaware of the dangers presented by the workstation if unsupervised. The manufacturer can in no way be
held liable for damage arising from improper use.
Intended use shall also include:
• Observation of all information from the assembly/operating manual and
• Prohibition of any sort of addition to/conversion of the workstation.

Improper use

• Never use the workstation to lift people or loads!!!
• Do not exceed the maximum load of the workstation frame (see Section "Technical
Specifications".
• Do not use the workstation frame in the home; alternatively, use it only in offices.

Laws, directives and standards to be observed

Laws, directives and standards to be observed
• Machinery Directive 2016/42/EG
• Low Voltage Directive 2014/35/EU
• Electromagnetic Compatibility Directive 2004/30/EU

FCC information for class B digital device (power supplies)

This equipment has been tested and found to comply with the limits for a class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
4
VXDKB EN