Safety Check; Commissioning The Product; Preparing To Setup The Product; Setting Up The Product - Ford Connected Wall Box Installationsanleitung

NOTE
You must make sure that the drill holes are at least 95
mm (4 inches) deep.
1. Take the mount dock rear holder out of the box.
2. Mark the drill holes by using the rear part of the dock
holder as a template.
3. Drill two holes (8 mm / 5/16 inch) in the marked posi-
tions.
4. Push the two dowels (8 x 50 mm / 5/16 x 2 Inches)
firmly into the drill holes.
5. Use a Torx T20 screwdriver and two screws (6 x 90
mm / ¼ x 3.5 inches) to mount the dock's rear holder
on the wall.
Fig. 16
6. Carefully clip the dock front cover onto dock's rear
holder.
Fig. 17
7. To mount the dock-insert onto the dock's front cover,
use two screws (5 x 12 mm / 1/5 x 4.5 inches) and a
Torx T25 screwdriver (torque: 1.8 Nm / 1.3 lb-ft).
Fig. 18
NOTE
You must attach the "C" label on one side of the remote
dock in such a way that it is easily visible during normal
usage. The label is an identification mark indicating
Type 2-compatible EV supply equipment in accordance
with EN 62196-2. Marking the dock with the supplied
self-adhesive label is mandatory according to regulatory
standard EN 17186.
5.4

Safety check

Document the results of the checks and measurements
carried out during initial startup, in accordance with the ap-
plicable installation requirements and standards. Local
regulations relating to operation, installation and environ-
mental protection also apply.
DANGER
High voltages.
Danger of fatal electric shock. Danger of confusion with
the drainage holes.
Ford Connected Wall Box Installation Manual

Commissioning the product

6
6.1

Preparing to setup the product

Steps to prepare for commissioning the wall box:
1. Download the FordPass™ app, this will be used to con-
nect your Ford Connected Wall Box to your FordPass
account.
2. Download the Ford Connected Wall Box Setup App,
this will be used to configure the wall box to your home
Wi-Fi.
3. Locate the Station ID and Access Code on the front of
this booklet. You will require these during the setup
process.
4. Make sure that you have a Wi-Fi signal (for the network
on which you want to use the wall box) at the wall box
location.
6.2

Setting up the product

1. Stand near to your wall box and turn on Bluetooth on
your smartphone.
2. Start the FordPass™ app.
3. Select More from the FordPass™ navigation bar.
4. Select Your wall box.
5. Follow the in-app instructions to complete the setup:
6. Select your Station ID from listed wall boxs.
7. Enter your Access Code.
8. Locate, and connect to your Wi-Fi network.
6.3 Displaying Software License
Information
You can view the open-source software license information
under the About option in the Ford Connected Wall Box
setup App. You must be logged into the same Wi-Fi net-
work as the Ford Connected Wall Box. Both devices must
be connected.

Decommissioning the product

7
The Ford Connected Wall Box must be decommissioned by
a qualified electrician.
The following steps apply:
1. Switch off the wall box circuit breaker.
2. Electrically disconnect the wall box.
SKLJ98-10C823-AA
3. Dispose of the Ford Connected Wall Box in accordance
with local and national rules and regulations.
EN
9