General Information; Purpose Of This Document; Using This Document; Intended Use - Ford Connected Wall Box Installationsanleitung

1

General information

1.1

Purpose of this document

This document is part of the product and contains informa-
tion for electricians to carry out safe installation in accord-
ance with local regulations, standards, and requirements.
NOTE
In addition to this document, follow and comply with
local regulations and standards relating to operation,
installation and environmental protection.
1.2

Using this document

Read this document carefully before installing and
u
starting the Ford Connected Wall Box.
Keep these instructions ready to hand.
u
Keep these instructions for future reference.
u
Pass this manual on to the next owner or user of the
u
Ford Connected Wall Box.
1.3

Intended use

The Ford Connected Wall Box is designed for charging elec-
tric vehicles in accordance with IEC 61851-1, charge mode 3.
In this mode the wall box ensures that:
– The voltage is not applied before the vehicle has been
properly connected.
– The maximum power is calibrated.
– The AC/DC converter is in the vehicle.
The wall box does not support ventilation, therefore if the
EV requests ventilation, the EVSE (electric vehicle supply
equipment) will not energize the system.
1.4

Use of symbols and highlighting

DANGER
This signal word denotes a hazard with a high degree of
risk which, if not avoided, will lead to death or serious in-
jury.
WARNING
This signal word denotes a hazard with a moderate de-
gree of risk which, if not avoided, may lead to minor or
moderate injury.
Ford Connected Wall Box Installation Manual
CAUTION
This signal word denotes a hazard with a low degree of
risk which, if not avoided, will lead to minor or moderate
injury.
NOTE
This image denotes a special technical feature, or (if not
observed) potential damage to the product.
1.5

Software licenses

This product uses open-source software. Further informa-
tion, such as disclaimers, written offers, and license inform-
ation, is available through the Ford Connected Wall Box
setup app. See also chapter 6.3, "Displaying Software Li-
cense Information" on page 9.
SKLJ98-10C823-AA
EN
1