Sony SDM-HX73 Handbuch Seite 48

Symptom
Picture is fuzzy.
Picture is ghosting.
Picture is not centered or sized
properly (analog RGB signal only).
Picture is too small.
Picture is dark.
Wavy or elliptical pattern (moire)
is visible.
Color is not uniform.
White does not look white.
Monitor buttons do not operate
( appears on the screen).
Resolution displayed on the menu
screen is incorrect.
Check these items
• Adjust the contrast and brightness (page 13, 14).
• Adjusting the sharpness (page 15).
• Adjust the pitch and phase (analog RGB signal only) (page 16).
xProblem caused by a connected computer or other equipment, and not
caused by the monitor
• Set the resolution to 1280 × 1024 on your computer.
• Eliminate the use of video cable extensions and/or video switch boxes.
• Check that all plugs are firmly seated in their sockets.
• Adjust the pitch and phase (page 16).
• Adjust the picture position (page 17). Note that some video modes do not fill the screen to
the edges.
xProblem caused by a connected computer or other equipment, and not
caused by the monitor
• Set the resolution to 1280 × 1024 on your computer.
• Adjust the backlight (page 13).
• Adjust the brightness (page 14).
• Adjust the gamma on the GAMMA menu (page 14).
• It takes a few minutes for the display to become bright after turning on the monitor.
• When the mode is set to AUTO, the display brightness may become dark in low
ambient light (page 13, 20).
• Adjust the pitch and phase (analog RGB signal only) (page 16).
• Adjust the pitch and phase (analog RGB signal only) (page 16).
• Adjust the color temperature (page 14).
• If "MENU LOCK" is set to "ON," set it to "OFF" (page 18).
• Depending on the graphics board setting, the resolution displayed on the menu screen may
not coincide with the one set on the computer.
GB
(continued)
23