Troubleshooting; Warranty - GYS CONVERGYS 300 Betriebsanleitung

Translation of the original instructions

TROUBLESHOOTING

SYMPTOM
No voltage output
The device turns ON and
OFF intermittently
The inverter turns OFF
when a connected device
is switched ON
Warning Buzzer sounds
Red LED illuminates
The Convergys doesn't
supply any voltage
Warning Buzzer sounds +
red LED
illuminates
The Convergys doesn't
supply any voltage
NB: The USB socket should continue to operate.

WARRANTY

The warranty covers faulty workmanship for 2 years from the date of purchase (parts and labour).
The warranty does not cover:
• Transit damage.
• Normal wear of parts (eg. : cables, clamps, etc..).
• Damages due to misuse (power supply error, dropping of equipment, disassembling).
• Environment related failures (pollution, rust, dust).
In case of failure, return the unit to your distributor together with:
- The proof of purchase (receipt etc ...)
- A description of the fault reported
10 10 10
CONVERGYS 300
CAUSES
Bad connection
Weak battery
Thermal overload
Fuse failure (in the inverter or vehicle)
The direct load is too high.
The starting current is too high.
Input current below the required level
(10.2-10.8 V)
Input current is below the protection
level (9.2-9.8 V)
Input voltage exceeds the protection
level (15-16 V)
Excessive load, the protection is acti-
vated.
The temperature is too high.
REMEDIES
Check the cigarette lighter plug and cable
connections
Check the vehicle battery
Start the engine of the vehicle if necessary
Stop the device. Leave the inverter to cool
ensuring adequate ventilation.
Check and replace fuse
Reduce the load
Check if the maximum power of the inver-
ter is suitable for the required power of the
device
The unit will start again when the battery
voltage reaches the operating level of the
inverter.
The unit will start again when the battery
voltage drops to the operating level of the
inverter.
Reduce the charge to the power level of the
converter
The inverter will start again as soon as it has
cooled down.
EN