Commissioning; Operation; Maintenance And Repair; Decommissioning - Bosch REXROTH VM350 Bedienungsanleitung

3 609 929 B32/2008-09 | VM350
1. Switch off the power supply for the
BT356 card rack or SB35x system box
and allow for a discharging time of
10 seconds.
2. Completely insert the VM350 power
supply module into the slot furthest to the
left in the BT356 card rack or into the
SB35x system box.
3. Tighten the knurled bolts on the front.
Make sure that the front panel is flush to
the BT356 card rack or SB35x system
box by tightening the knurled bolts.
7

Commissioning

CAUTION
Risk of damage to persons
and property!
Commissioning of the VM350
power supply module requires
basic mechanical and electrical
knowledge.
y Only qualified personnel (see
"Personnel qualifications" on
page 22) are authorized to
commission the system.
y Once the device has been
switched off, it cannot be
switched back on again until
at least 30 seconds have
elapsed.
Before commissioning, check that all plug-in
connections are correctly fitted.
Bosch Rexroth AG
8

Operation

Operation is not necessary while the system is
running.
9 Maintenance and
repair
Cleaning and care
CAUTION
Any dirt or liquids penetrating
the device lead to
malfunctions!
Safe function of the VM350 power
supply module is no longer
ensured.
y Pay particular attention to the
utmost cleanliness when
working with the VM350
power supply module.
Maintenance
The VM350 power supply module is
maintenance-free if used as intended.
Spare parts
Please refer to the address directory under
www.boschrexroth.com and in chapter
"16 Service and sales" on page 38 for the
addresses of our foreign subsidiaries.
10

Decommissioning

For details on how to disassemble or replace
your VM350 power supply module, please
refer to chapter "11 Disassembly and
replacement" on page 36.
35/112