Supra ARTEMIS + Bedienungsanleitung Seite 7

ASSEMBLING THE GRILL AND THE
PROPELLER:
- Fit the rear grille (H) on the motor housing (K),
matching their fitting points.
- Tight the grille fastening nut (G), make sure of a
correct setting.
- Fit the blades (E) on the motor shaft (J), match-
ing their fitting points.
- Tight the blades fastening nut (D), make sure of
a correct setting.
- Fit the front grille (C) in front of the rear grill (H),
matching the security screw position. Fix the
front grille through the grille ring (F) and tight
the security screw by using a screwdriver.
- Check the correct rotation of the blades.
INSTRUCTIONS FOR USE
USE:
- Extend the cable completely before plugging
it in.
- Connect the appliance to the mains.
- Guide the appliance to direct the flow of air in
the desired direction.
- Turn the appliance on, by using the speed
selector button (a, I).
TIMER FUNCTION:
- The appliance's operating time can be con-
trolled.
- To program the operating time simply select it
using the (b, II) buttons.
- After the selected time the appliance will switch
off automatically.
OSCILLATION FUNCTION:
- The oscillation function makes it possible to
direct the flow from the apparatus so that it
automatically alternates over a range of 75º.
- To activate this function, press the (d, IV)
button.
- To deactivate this function, follow the proce-
dure for switching it on in reverse.
HEIGHT ADJUSTMENT
- The appliance height can be adjusted, it's just
necessary to unlock the inner tube fastening
knob (N), place the inner tube (L) at the desired
height and lock again the inner tube fastening
knob (N).
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Stop the appliance using the OFF button (c, III).
- Unplug the appliance from the mains.
- Clean the appliance.
CARRY HANDLE/S:
- This appliance has a handle on the upper
part of the body, which facilitates comfortable
transportation (I).
SAFETY THERMAL PROTECTOR:
- The appliance has a safety device, which pro-
tects the appliance from overheating.
CLEANING
- Disconnect the appliance from the mains and
allow it to cool before undertaking any cleaning
task.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Do not let water or any other liquid get into the
air vents to avoid damage to the inner parts of
the appliance.
- Never submerge the appliance in water or any
other liquid or place it under running water.