Ce Declaration Of Conformity - Fermax BASIC-2B Benutzerhandbuch

Cod. 97853 V06_17
Single reset
In programming mode, held down and the reset "MR" and by pressed the transmitter you want to
delete, and you will hear a confirmation tone. After 10 seconds without programming or quickly
pressing the programming button, the receiver will exit programming mode, issuing two acoustic
signals of 1 sec.
GROUPS
Receivers can be configured with a group (from 0 to 7) so that there is no interference when
working near each other.
GROUP CONFIGURATION
The configuration can be carried out with the programming tool or by self‐programming as
follows.
Self‐programming After the receiver has been totally reset, it will be configured with the group of
the first radio‐programmed transmitter by enabling the hands free mode.
Exception: If the receiver has been configured using programming tools, the group may only be
changed with the programming tool.
Operations On powering the receiver, the led R1 will flash the same number of times as the group
number with which it is configured.
WARNINGS
Disconnect the power supply before handing the unit.
In compliance with the European Directive low‐voltage electrical equipment, we hereby inform
users of the following requirements:
∙ For units which are permanently connected, an easily accessible circuit‐breaker device must be
built into the wiring system.
∙ This unit must always be installed in a vertical position and firmly fixed to the structure of the
building.
∙ This unit must only be handled by a specialised installer, by his maintenance staff or by a duly
trained operator.
∙ The instruction manual for this unit must always remain in the possession of the user.
∙ Terminals of maximum section 3,8mm2 must be used for the power supply connections.
∙ Use time delayed fuses.
CE DECLARATION OF CONFORMITY
Hereby, FERMAX ELECTRONICA, S.A.U., declares that this BASIC‐2B ref. , is in compliance with the
essential requirements of Directive RED 2014/53/UE and Directive RoHS 2011/65/UE. See website
www.fermax.com.
http://docweb2.fermax.com/docs/decconformidad/EN/F05250.pdf
FERMAX Avd. Tres Cruces, 133, 46017
11
Valencia, Spain.
3200683