Storage Conditions; Disassembly, Disposal - resideo Braukmann CBU146 Einbauanleitung

Our customer service department is at your service.
Failure to comply will lead to loss of any liablity claims.
12 Shut-down, restart
12.1 Shutting down the compact booster
unit
1. Set main switch to 0.
2. Secure the system against unintentional operation
Empty the compact booster unit if it is shut down for a
longer period of time.
12.2 Restarting the compact booster unit
Please note the procedures in chapter 8
13 Storage
13.1 Short-term storage
Short-term storage is possible without further preparation
under the specified environmental conditions.
13.2 Storage/Preservation
CAUTION!
Damage during storage caused by frost, humidity,
dirt, UV radiation or pests
Corrosion/Contamination of the system!
 Protect the system against frost, do not store outside.
CAUTION!
Damp, dirty or damaged openings and junctions
Danger of leaks and damaging the system!
 Uncover openings in the system only during
installation.

13.3 Storage conditions

Storage location closed room, dry and dust-free
Ambient temperature 5°C to 40°C (incl. power pack)
Relative air humidity max. 80% r.h.

14 Disassembly, disposal

Observe the local requirements regarding correct waste
recycling/disposal!
14.1 Safety instructions for disassembly
DANGER!
Unintentionally switching on the compact booster
unit
Danger to life!
 The compact booster unit has to be voltage free
during disassembly. Turning off the system with the
motor protection switch does not securely shut off the
motor inlet lines.
MU1H-1376GE23 R0320
GB
 Only perform maintenance work on the compact
booster unit if you are sure that the compact booster
unit is free of power.
 Secure the compact booster unit against being
switched on unintentionally.
DANGER!
Danger of injury from electric voltage.
High shock currents and burns from direct and indirect
contact with live parts.
 Turn off the power supply before disassembling the
compact booster unit and secure it from being turned
on.
WARNING!
Components and lines under pressure
Personal and property damage!
 Before work is done on pressure-retaining
components, the pump has to be depressurised!
 Disconnect the pump from the power supply!
WARNING!
Inappropriate lifting/moving of heavy modules or
components
Personal and property damage!
When moving heavy modules or components, use

suitable transport devices, lifting devices and lifting
accessories.
WARNING!
Danger through improper disassembly
 Performance of tasks only by qualified personnel (see
section 1.13 Requirements for operating personnel).
It is imperative to observe the laws and regulations on
waste disposal of materials that are detrimental to the
environment.
1. Disassembly of the system.
– Collect grease and lubricants during disassembly.
2. Separate the pump materials for example according
to:
– Metal
– Plastic
– Electronic junk
– Grease and lubricants
3. Dispose according to local regualtions or have them
disposed of according to regulations.
17