ASROCK J3160TM-ITX Handbuch Seite 18

16
Downloaded from www.Manualslib.com
Chassis Fan Connector
(4-pin CHA_FAN1)
(see p.1, No. 9)
CPU Fan Connector
(4-pin CPU_FAN1)
(see p.1, No. 7)
Internal Power Header
(2-pin ATX19V_IN1)
(see p.1, No. 30)
Consumer Infrared
Module Header
(7-pin CIR1)
(see p.1, No. 10)
Serial Port Header
(9-pin COM1)
(see p.1, No. 17)
Backlight Control
Header
(8-pin BLT_VOL1)
(see p.1, No. 16)
manuals search engine
Please connect fan cable
GND
+12V to the fan connector and
CHA_FAN_SPEED
match the black wire to
FAN_SPEED_CONTROL
the ground pin.
This motherboard pro-
FAN_SPEED_CONTROL
CPU_FAN_SPEED
vides a 4-Pin CPU fan
+12V
(Quiet Fan) connector.
GND
If you plan to connect a
3-Pin CPU fan, please
connect it to Pin 1-3.
This motherboard
provides a 2-pin ATX 19V
power connector.
This header can be used to
CIR input
+5VA
connect the remote controller
Learn-in
LED
receiver.
1
+5VA
IRTX
GND
This COM1 header
NC
RI
supports a serial port
RTS CTS
GND
DSR
module.
TXD
DTR
DCD
RXD
1
1: Backlight Enable
1
2: Backlight Control
3: Backlight Power
4: Backlight Power
5: GND
6: GND
7: Brightness_Up
8: Brightness_Down