Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.1, No. 25)
Analog Surround
Audio Header
(17-pin HD_AUDIO2)
(see p.1, No. 28)
3W Audio AMP Output
Wafer Header
(4-pin SPEAKER1)
(see p.1, No. 27)
Downloaded from
www.Manualslib.com
GN D
PRESENCE#
MIC_RET
OUT_RET
1. High Definition Audio supports Jack Sensing, but the panel wire on the chassis
must support HDA to function correctly. Please follow the instructions in our
manual and chassis manual to install your system.
2. If you use an AC'97 audio panel, please install it to the front panel audio header by
the steps below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for the HD audio panel only. You don't need to
connect them for the AC'97 audio panel.
E. To activate the front mic, go to the "FrontMic" Tab in the Realtek Control panel
and adjust "Recording Volume".
2
1
Front_L-
Front_L+
manuals search engine
This header is for
OUT2_L
connecting audio devices
J_SENSE
OUT2_R
to the front audio panel.
MIC2_R
MIC2_L
1
Signal
PIN
Name
18
SENSE
16
LFE
14
A_GND
12
Surr_Rear_R
10
A_GND
8
Surr_Side_R
1
6
A_GND
4
Front_R
2
A_GND
Please connect the chassis
speaker to this header.
Front_R+
Front_R-
J3160TM-ITX
Signal
PIN
Name
17
KEY
15
A_GND
13
Center
11
A_GND
9
Surr_Rear_L
7
A_GND
5
Surr_Side_L
3
A_GND
1
Front_L
15
Werbung
Inhaltsverzeichnis
