Care And Cleaning; Troubleshooting - ZANKER KEV6340FBB Benutzerinformation

Heat
setting
4-5 Steam potatoes
4-5 Cook larger quantities of food, stews and
soups
6-7 Gentle fry: escalope, veal cordon bleu, cut-
lets, rissoles, sausages, liver, roux, eggs,
pancakes, doughnuts
7-8 Heavy fry, hash browns, loin steaks, steaks
9 Boil large quantities of water, cook pasta, sear meat (goulash, pot roast), deep-fry chips

Care and cleaning

Clean the appliance after each use.
Always use cookware with clean bottom.
Scratches or dark stains on the glass-ceramic
cause no effect on how the appliance operates.
To remove the dirt:
1. – Remove immediately: melted plastic, plastic
foil, and food with sugar. If not, the dirt can
cause damage to the appliance. Use a special
scraper for the glass . Put the scraper on the
glass surface at an acute angle and move the
blade on the surface .

Troubleshooting

Problem
You cannot activate the appliance or
operate it.
An acoustic signal sounds and the
appliance deactivates.
An acoustic signal sounds when the
appliance is deactivated.
Use to:
Possible cause
The appliance is not connected to
an electrical supply or it is connec-
ted incorrectly.
You touched 2 or more sensor fields
at the same time.
There is water or fat stains on the
control panel.
You put something on one or more
sensor fields.
Time
20-60 min Use max. ¼ l water for 750 g of potatoes
60-150 Up to 3 l liquid plus ingredients
min
as neces- Turn halfway through
sary
5-15 min Turn halfway through
– Remove after the appliance is sufficiently
cool: limescale rings , water rings, fat stains,
shiny metallic discolorations. Use a special
cleaning agent for glass ceramic or stainless
steel.
2. Clean the appliance with a moist cloth and some
detergent.
3. At the end rub the appliance dry with a clean
cloth.
Check if the appliance is correctly
connected to the electrical supply
(refer to connection diagram).
Activate the appliance again and set
the heat setting in less than 10 sec-
onds.
Touch only one sensor field.
Clean the control panel.
Remove the object from the sensor
fields.
Hints
Remedy
17