Sensor Installation; Sensor Setup - BALDR B0359WST2H2PR Bedienungsanleitung

SENSOR INSTALLATION

1. Remove the battery compartment cover;
2. Insert 2 x AA batteries in each sensor matching the polarity
（ +and-);
3. Replace the battery cover.

SENSOR SETUP

● Switch the Channel 1-2-3 of the senor to any channel you want.
For example, you can set to Channel 1 for the sensor. But please
ensure the main unit are set to the same channel before
synchronization. Special note: Press "▲/ CH" button on the main
unit to set the channel. The setting order is CH1--CH2--CH3--
Channel scan(from CH1 to CH2 to CH3, 10 seconds intervals),
you must select the same number choices for both the sensor
and the main unit in order to synchronize.
● Power the main unit prior to load the battery of sensor.
Notes:
1. Main unit will auto receive outdoor signal after power on, the
receiving status will last for max 3 minutes. The receiving
antenna signal will flash. If no signal received in 3 minutes,
it will stop receiving outdoor signal.
2. If the main unit is out of 3 minutes' signal receiving window,
you need to press and hold the "▲/ CH " button to enter
signal receiving again.
10