Getting Start; Sensor Installation; Sensor Setup - BALDR B0359WST4H4PR Bedienungsanleitung

BALDR recommends high quality alkaline or lithium
batteries for the best product performance. Heavy duty
or rechargeable batteries are not recommended.
MAIN UNIT INSTALLATION
Remove the cell battery's Insulating strip ,then plug the
adaptor to a powered outlet.

SENSOR INSTALLATION

1. Remove the battery compartment cover;
2. Insert 2 x AA batteries in each sensor matching the polarity
（+and-);
3. Replace the battery cover.

SENSOR SETUP

● Power the main unit prior to load the batteries of sensor.
● Switch the button of 3 sensors to CH1 , CH2 and CH3 ( the
channel of each sensor should be different from others).
Note: 1. Main unit will auto receive outdoor signal after power
on, the receiving status will last for max 3 minutes.
The receiving antenna signal will flash. If no signal
received in 3 minutes, it will stop receiving outdoor
signal.
2. If the main unit is out of 3 minutes' signal receiving
window, you need to press and hold the " CH " button
to enter signal receiving again.

GETTING START

7