seko TEKNAEVO TPG Handbuch Seite 8

Display during Operation
Operating mode
1:n = impulse
•
multiplication
Alarms and statuses
Lev = Level alarm
•
Flw = Flow alarm
•
Paragraph 7 – Proportional to External Impulses (batch dosage)
Programming
PROG
Configuration
Pump Funtions
-
+
Pump Functions
Batch mode (1:c)
Batch mode (1:c)
Q.ty - 10.0ml
Batch mode (1:c)
Time - 10s
Batch mode (1:c)
Memory Off
-
Display during Operation
Operating mode
•
Batch
Alarms and statuses
•
Lev = Level alarm
•
Flw = Flow alarm
•
Mem = Memory alarm
EM00136424
FLOW
sensor
status
N:1 F 4
F
F
Lev Stop P100%
Pump status
Empty = pump in start
•
Stop = pump stationary
•
Paus = pump in pause
•
The pump doses in proportion to an external signal (i.e.: impulse
launch counter). In this case, it is possible to set the quantity to be
dosed in ml and the time within which to complete dosage.
Dosage can be started manually by pressing the
using a remote control. The
already made can be reset by pressing the
-
+
by pressing the
-
The quantity to be dosed can be modified during operation, by
+
pressing the
-
+
or the
FLOW
Memory
sensor
function
status
status
•
Batch F F F M M M 7.0ml
Lev Stop 0
Pump status
•
Empty = pump in start
•
Stop = pump stationary
•
Paus = pump in pause
rev. 1.0
Programmed
value of n
Current dosage value
Maximum dosage
•
percentage
key again.
keys to decrease i.
Programmed value
Quantity in ml
Current dosage value
•
Gradually displays
the dosed quantity
EN
Display during Setting (MODE key)
Operating mode
n:1 6
6 P100%
Effective
Current dosage value
value of "n"
•
The dosage % can be modified
by pressing the + or – keys at
the same time
Operation
key interrupts dosage. The dosage
keys at the same time to increase the flow,
Display during Setting (MODE key)
Operating mode
•
Displays in sequence: quantity to
be dosed, dosage time and pump
frequency
Q.ty 7.0ml
7.0ml
Dosage value
•
The quantity can be modified by pressing the
+ or – keys at the same time
Programmed value
•
Value of n
key, or by
key, or started again
6