Herunterladen Inhalt Inhalt Diese Seite drucken

Display During Operation - seko TEKNAEVO TPG Handbuch

Vorschau ausblenden Andere Handbücher für TEKNAEVO TPG:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Display during Operation

Instantaneous flow rate
from flowmeter
Alarms and statuses
Lev = Level alarm
Flw = Flow alarm
Mem = Memory alarm
(the pump has reached the
maximum dosage
frequency)
Paragraph 5 – Proportional to External Impulses (multiplication)
Programming
PROG
Configuration
Pump Funtions
-
+
Pump
Functions
Multiply (1:n)
Multiply (1:n)
n
4
-
Multiply (1:n)
Timeout
-
0s
Multiply (1:n)
Memory
Off
-
Display during Operation
Operating mode
1:n = impulse
multiplication
Alarms and statuses
Lev = Level alarm
Flw = Flow alarm
Mem = Memory alarm
Paragraph 6 – Proportional to External Impulses (division)
Programming
PROG
Configuration
Pump Funtions
-
+
Pump
Functions
Divide (n:1)
Divide (n:1)
n
4
-
EM00136424
FLOW
sensor
status
50L/h
F
F
F
Lev
Stop
P3,1%
Pump status
Empty = pump in start
Stop = pump stationary
Paus = pump in pause
The pump doses in proportion to an external signal (i.e.: impulse launch
counter). With every signal received, the pump makes the programmed
"n" number of strikes. The pump automatically sets the dosage frequency,
adapting it to the time that passes between two successive signals. It is
possible to set the time (timeout) in seconds, beyond which the pump
resets the interval count in order to avoid dosages over excessively long
times. The pump has a memory function, which signals the reception of a
signal during dosage. If set to Off, it merely sends a signal, if set to On it
-
sends a signal and memorises the impulses, then executes them when it
+
has finished receiving signals.
-
The value of "n" can be modified during operation, by pressing the
+
-
keys at the same time to increase the flow, or the
+
decrease it.
FLOW
Memory
sensor
function
status
status
1:n
F
M
1
F
M
F
M
Lev
Stop
0
Pump status
Empty = pump in start
Stop = pump stationary
Paus = pump in pause
The pump doses in proportion to an external signal (i.e.: impulse launch
counter). At every "n" signals, the pump makes a strike. You can set the
value of "n" during programming. By programming the value of "n" you set
the maximum dosage %. This value can be modified during operation, by
pressing the
-
+
Current dosage value
Dosing
percentage set in
programming
Programmed
value of n
Current dosage value
Displays stroke
countdown
keys at the same time to increase the flow, or the
keys to decrease it.
rev. 1.0
EN
Display during Setting (MODE key)
Displays the settable
percentage value.
PERC
P1.0%
Current dosage value
This value can be modified by pressing
the + or – keys at the same time with
mode button. "1.0%" will blink during
circular visualization.
Operation
Display during Setting (MODE key)
Displays programmed
timeout
Timeout
0s
Current dosage value
Displays the value of n. This
can be modified by pressing
the + or – keys at the same
time
Operation
keys to
n
1
5

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis