Part Counter (Optional); Containers (Optional); Automatic Feed System (Optional); Overview - honsel S-416 Plus Bedienungsanleitung

2 .4 .7 Part counter (optional)

The part counter consists of the following functions:
• Stroke counter
• Part counter
• Job counter with beeper
Stroke counter
This counter counts the finished strokes. When the
upper tool holder has moved completely down and
back again, this is called a stroke.
Part counter
This counter counts the finished workpieces.
Job counter with beeper
This counter counts how many self-clinching
fasteners that have to be pressed into a workpiece
have already been pressed in. After all self-clinch-
ing fasteners are pressed into the workpiece, there
is a sound.
12
6
11
Figure 7 Part counter
No . Designation
1 Switch Out
2 Switch Power
3 Job Counter
4 Total number of self-clinching fasteners
that have to be pressed into the
workpiece
5 Number of self-clinching fasteners
already pressed into the workpiece
6 Switch Reset
7 Switch Select
8 Switch Increase/Decrease
9 Switch Reset For Current Workpiece
10 Part Counter
11 Beeper
1 2 3
7 8 9
No . Designation
12 Stroke Counter

2 .4 .8 Containers (optional)

The containers are used to store self-clinching
fasteners or workpieces.

2 .4 .9 Automatic feed system (optional)

An automatic feeding of the self-clinching fasteners
replaces the manual insertion of the self-clinching
fasteners.
4
The self-clinching fasteners are in the feed tank.
5
The self-clinching fasteners are led over the
orientation module and the separation module to
a loading device. The loading device places the
self-clinching fastener on the workpiece.

2 .4 .9 .1 Overview

10
7
Figure 8
No . Designation
1 Orientation module
2 Separation module
3 Holder separation module
Contact the HONSEL service for
further information.
Contact the HONSEL service for
further information.
There are several possibilities
of automatic feeding. Contact
the HONSEL service for further
information.
6 5
Feed system
1
2
3
4
English | 39