Comet DSG-6 DP Bedienungsanleitung Seite 22

EN
(see fig. B)
Adjust the temperature by means of the ther-
mo regulator situated on the control panel.
This machine is equipped with an electronic
thermo regulator to check and adjust the boi-
ler temperature as well as the pressure from
min. 5 bar to max. 10 bar.
- When turning the unit on, the display shows
the temperature reading in the boiler.
Adjust the temperature as follows:
- Hold the ( + ) and ( - ) buttons pressed simul-
taneously for a few seconds;
- Press the ( + ) button to increase the tempe-
rature, or the ( - ) button to decrease it.
It is essential that the thermo regulator is set
to 190°C in order to be able to work at 10
bar.
TABLE OF COMPARISON BETWEEN DEGREES
CENTIGRADE AND STEAM PRESSURE EXPRES-
SED IN BAR
° C bar
152 5
159 6
WARNING:
165 7
- The machine is pre-set at
170 8
the max temperature of 190 °C.
175 9
180 10
- For
timing or replacement action
not described in this handbook, contact
qualified personnel at the manufacturer or
resale outlet.
- Adjustments can be made to adapt the
machine to various production requirements.
> Steam and water output adjustment
(see fig. B)
Adjust the steam and water output by using the
two knobs situated on the the left hand side of
the machine (23.).
wet steam ;
> Steam gun
Use of the steam gun
- Plug the lance jack into the appropriate so-
any adjustment,
dry steam ;
cket and lock it with the two levers;
- To obtain a spray of steam, press the trigger
on the pistol grip;
WARNING:
- For any subsequent adjustment, setting or
replacement of parts not foreseen in this
manual, please contact qualified personnel
at the manufacturer or resale outlet.
- Before carrying out any replacement, ensure
that the main switch is in the (0) OFF position.
> START-UP
Description of the start sequence.
After carrying out all the connections and pre-
ventative inspections described in the pre-
vious chapters, start the machine according
to the following instructions:
1) Before starting the generator, fill the tanks
with water and DIESEL up to the set level.
2)Turn main switch situated on the control pa-
nel to the position
- If the display show H2O , it means that there is
no water in the tank. Fill the tank (see "Filling
the tanks with water and detergent")
> TO SPRAY DETERGENT
To spray and mix the detergent with steam:
- Press button (2.) on the pistol grip.
> Machine stop (at end of work)
At the end of the work shift, stop the machine
in the following way:
1) Turn main switch to (0) OFF (24.).
2) Unplug the machine from the electrical po-
wer supply.
Boiler steam discharge
Follow the instructions below:
- A few minutes before the end of the work
shift, turn off the boiler, continuing to use
the steam gun until the pressure gauge indi-
cates a value of 0-1 bar;
- Open the safety catch see fig. D
- Carefully open the boiler drain tap, and drain
all the water from the boiler into a suitable
22