Operation And Control - Silvercrest SRB 6 A1 Bedienungsanleitung Und Sicherheitshinweise

♦ To remove an attachment
holder
Fig. 6

Operation and control

CAUTION - DAMAGE TO APPLIANCE!
► Do not use abrasive cleaning agents. They could irreparably damage
the surface you are cleaning.
► The hard bristles and the scrubbing sponge pad of the attachments
9 8
/
hicle paintwork, stainless steel, copper, wood, etc. First test the attachments
9 8
/
NOTE
► Use the appliance with water; for more difficult stains use a mild cleaning
detergent. Apply the detergent directly onto the attachment
and/or on the area to be cleaned before switching on the appliance.
► After every use clean the appliance and the used attachments
as explained in the section Cleaning and maintenance.
♦ Hold the appliance tightly over the area to be cleaned.
♦ Switch on the appliance by pressing the On/Off switch
♦ Move the attachment
be cleaned. Apply more water and/or cleaning detergent, as needed, to
the area to be cleaned.
♦ Once you have finished using the appliance, press the On/Off switch
again to switch it off.
■ 8 │ GB │ CY
9
0
with a small amount of force (see fig. 7).
7 6
/ / can scratch or damage sensitive surfaces such as glass, ve-
7 6
/ / on an inconspicuous spot of the area to be cleaned.
9 8
/
8 7 6
/ / / , pull it from the attachment
Fig. 7
7 6
/ / with light pressure over the area to
9 8 7 6
/ / /
9 8 7 6
/ / /
2
.
2
SRB 6 A1