Before Use; Installing / Replacing Batteries; Mounting The Attaching Cord; Operation - Silvercrest HG03848 Bedienungs- Und Sicherheitshinweise

Only use the same type of bat-
teries / rechargeable batteries.
Do not mix used and new batter-
ies / rechargeable batteries.
Remove batteries / rechargeable
batteries if the product will not
be used for a longer period.
Risk of damage of the product
Only use the specified type of
battery / rechargeable battery!
Insert batteries / rechargeable
batteries according to polarity
marks (+) and (-) on the bat-
tery / rechargeable battery and
the product.
Clean the contacts on the bat-
tery / rechargeable battery and
in the battery compartment be-
fore inserting!
Remove exhausted batteries /
rechargeable batteries from the
product immediately.

Before use

Remove all parts from the packaging.
Note: Remove all packaging material from
the product.

Installing / replacing batteries

(see Fig. A)
Press "0" on the On / Off
button before installing the batteries
1
8 GB/IE/NI
Open the battery compartment by squeezing
the dots located on front and back of base of
handle and pull off the cap
Slide out the battery tray
Insert / replace 4 batteries 1.5 V AA
the battery tray
The polarity is indicated inside the battery
tray .
4
Slide in the battery tray
Reattach the cap
cap with the one on the bottom of hand-
2
held unit
in the place.

Mounting the attaching cord

Thread the end of short loop of the attaching
cord through the hole at base of cap
5
(Fig. B).
Insert the opposite part of the end of attaching
cord with the plastic toggle through the
5
loop. The attaching cord
the cap
2
The large loop is now available to hang on a
peg or over a showerhead or faucet.
The cleaning brush can also stand on its base
for easy and upright storage.

Operation

Select a suitable brush head
based on the type of dirt and the surface
10
being cleaned.
To change the brush heads, grip lower half of
handheld unit
head with other hand.
Turn the brush counter-clockwise
(Fig. C1).
To attach another brush head, hold the hand-
held unit
head.
Note: Always set the On / Off button
position „0" when changing brush head.
. Align the guide lugs of the respective brush
3
head with the guide rails of the handheld unit
.
2
.
4
, noting the polarity (+ and -).
4
.
4
by aligning the dot on
2
. Push the cap on until it snaps
11 2
is snug against
5
.
,
6
with one hand and brush
11
and pull down selected brush
11
into
3
2
, , ,
7 8 9
and pull up
to
1