Technical Specifications; Troubleshooting And Cleaning; Maintenance And Cleaning - THOMSON MIC200 Bedienungsanleitung

TECHNICAL SPECIFICATIONS

• Remote control power source: 2 LR3 (AAA) 1.5V batteries (not included).
•Mains adapter: Input: 100-240V ~ 50/60Hz - 1.0A / Output: 15V/2500mA.
• Frequency range: FM: 87.5 - 108.0 MHz
• Consumption: 10W maximum
Note: Unit design and specifications are subject to change without notice. The manufacturer reserves the right to make the
necessary improvements.

TROUBLESHOOTING AND CLEANING

Problems
No power
No sound
The appliance doesn't
start playing.
The remote control does
not work properly.

mAINTENANCE AND ClEANING

• Unplug the appliance before cleaning it.
• Remove fingerprints and dust with a soft and slightly damp cloth. Do not use abrasive products or solvents that may
damage the appliance's surface.
ATTENTION: Never immerse the appliance in water or in any liquid whatsoever.
• If it is not used for a long time, unplug the appliance and remove the batteries.
Monday to Thursday (from 9 am to 18 pm) and Friday (9 am to 3:30 p.m.)
EN 12
Cause
• The power supply cable is
disconnected.
• The external source equipment is off.
• No disc has been inserted into the tray.
• The disc in the tray cannot be read.
• The disc is upside down.
• The disc is not inside the guide.
• The disc is dirty.
• The remote control is not pointed
towards the appliance sensor.
• The remote control does not activate
the appliance.
• There is an obstacle between the
remote control and the appliance.
• The remote control batteries are flat.
is a trademark of TECHNICOLOR S.A. used under license by:
Parsons International France - 19 Boulevard Albert Einstein
77420 Champs sur Marne - France
N°Azur (+33 ) 0825 745 770
www.thomsonaudiovideo.eu
MICRO SYSTEM
MIC200
• Correctly connect the power supply cable to
the mains socket.
• Turn the external power source equipment on.
• Place a disc in the tray.
• Place a legible disc in the tray.
• Position the readable side of the disc
downwards.
• Correctly position the disc on the tray, inside
the guide.
• Clean the disc.
• Point the remote control towards the
appliance sensor.
• The remote control has an effective range of 5
metres or the angle of aim is not correct.
• Remove the object.
• Replace flat batteries with new ones.
call rate according to operator
Solutions