Power Supply; Using The Appliance - THOMSON MIC200 Bedienungsanleitung

USING

POWER SuPPlY

Speaker connection
• Unfurl the load speaker wires and connect them to the
corresponding terminals.
Red
Mains power supply
• Check that the appliance is off.
• Connect the mains adapter plug to the socket (G).
• Connect the adapter to a plug socket.
• Only use the adapter provided. To use another adapter,
check that it has identical characteristics and is
compliant with current standards.

uSING THE APPlIANCE

• Press q to turn the appliance on: the indicator light (C)
turns off.
• Press q button to turn the appliance to stand-by mode:
the indicator light (C) turns on.
COmmENTS CONCERNING TACTIlE KEYS
Tactile keys react to touch under normal conditions. They
do not react to greasy or wet fingers. Always clean and dry
the surface with a soft cloth. Do not use a damp cloth or an
aggressive detergent.
TImE SETTING
In Off mode:
• Press PROG/mEm of the device or PROG on the
remote and hold it down for 2 seconds.
• Press keys CH- and CH+ to switch between 12 or 24-
hour display.
• Press on the PROG/mEm of the device or PROG on
the remote: the display flashes.
• Set the time using the keys CH- and CH+. PROG/mEm
of the device or PROG on the remote to confirm.
• Repeat the previous operation to set the minutes.
EN 10
Black
MICRO SYSTEM
MIC200
uSING THE RADIO
• Turn the appliance on and press SOuRCE to select the
« TUNER » function.
• Tune the radio to the desired station using keys 5 and
6: the frequency is displayed on the LED screen.
• Press successively keys 5 and 6 to select an FM
station.
• Press the key 6 for 2 seconds to scroll through
frequencies, then release to trigger automatically on the
nearest station received.
• To turn the radio off, press the q button.
Note : For improved reception, unfurl the FM wire aerial (H)
located at the rear of the appliance.
PROGRAmmING RADIO STATIONS
Manual programming:
• Select a station to be saved.
• Press PROG/mEm of the device or PROG on the
remote : program mode (P- 01) is displayed.
• Press CH- and CH+ keys top select a number.
• Press PROG/mEm of the device or PROG on the
remote, to save each station (20 maximum).
• View the programmed radio stations using keys CH-
and CH+.
Automatic programming:
Press PROG/mEm of the device or PROG on the remote
for 3 seconds: programming will launch automatically and
memorize received stations.
Accessing saved stations:
• Press keys CH- and CH+ to access the saved stations.
RDS FuNCTION
The RDS (Radio Data System) function enables the
transmission of additional information from some stations.
To access these functions, press ID3/RDS on the remote
control to scroll through them in the following order:
• PS (Program Service): Displays the name of the radio
station
• PTY (Program TYpe): Gives the type of the program
broadcast from a predefined list of 32 types
• RT (Radio Text): Displays the references of the music
played (title, artist's name)
• CT (Clock Time): Displays the time sent by the station
and sets the time on the device
• Frequency display