HP LaserJet Pro MFP M28 Referenzhandbuch Seite 3

If your router supports Wi-Fi Protected Setup (WPS) mode, try to connect through this mode:
1. Press the WPS button on your router.
2. Within two minutes, press and hold the Wireless
The Wireless LED and the Ready
3. Wait while the printer automatically establishes the network connection. It takes up to two minutes. When the network connection is established,
the Wireless LED stops blinking and remains on.
4. Continue to install the software.
Check the Wireless LED status from the printer control panel:
1. If the Wireless LED is off, it means that the wireless connection is not established.
a. Press the Wireless
b. After the Wireless LED starts blinking, continue to install the software. When the network connection is established, the Wireless
blinking and remains on.
2. If the Wireless LED is on, it means that the wireless connection is established.
a. Check the network name (SSID) info on the Configuration Report/Network Summary: Press and hold the Start Copy
Ready LED starts blinking. After you release the Start Copy
b. Make sure the computer is connected to the same wireless network to which you are connecting the printer.
c. Continue to install the software.
3. If the Wireless LED is blinking, it means that the wireless connection is not established.
a. Restart the printer and the router.
b. Manually connect the printer to your wireless network. Use Wi-Fi Protected Setup (WPS) to connect the printer if the router supports WPS, or continue
to the next step.
c. Uninstall and reinstall the HP software.
Wireless printing
For more information on wireless
printing and wireless setup,
go to www.hp.com/go/wirelessprinting.
button on the printer control panel for at least three seconds, and then release the button.
LED start blinking together.
button on the printer control panel.
button, the Configuration Report/Network Summary prints.
3
LED stops
button until the