Philips 5400 Serie Benutzerhandbuch Seite 21

Problem
The machine seems to
be leaking.
I cannot activate the
AquaClean water filter
and the machine asks
for descaling.
The new water filter
does not fit.
The machine is making a
loud noise.
Cause
The machine uses water to rinse
the internal circuit and brew
group. This water flows through
the internal system directly into
the drip tray. This is normal.
The drip tray is too full and has
overflowed which makes it look
like the machine is leaking.
The water tank is not fully
inserted, some water is leaking
out of the water tank and air is
drawn into the machine.
The brew group is dirty/clogged. Rinse the brew group.
The machine is not placed on a
horizontal surface.
The filter has not been installed
or replaced in time after the
screen shows the AquaClean
reminder. This means your
machine is not anymore
completely limescale free.
You are trying to install another
filter than the Philips AquaClean
water filter.
The rubber ring on the
AquaClean water filter is not in
place.
It is normal that your machine
makes some noise during use.
The AquaClean water filter was
not prepared properly and air is
now drawn into the machine.
The water tank is not fully
inserted and air is drawn into
the machine.
Solution
Empty the drip tray every day or as
soon as the 'drip tray full' indicator pops
up through the drip tray cover. Tip:
place a cup under the dispensing spout
to collect rinsing water and reduce the
amount of water in the drip tray.
Empty the drip tray every day or as
soon as the 'drip tray full' indicator pops
up through the drip tray cover.
Make sure the water tank is in the
correct position: remove it and insert it
again pushing it as far as possible.
Place the machine on a horizontal
surface so that the drip tray does not
overflow and the 'drip tray full' indicator
works properly.
Descale your machine first and then
install the AquaClean water filter.
Only the Philips AquaClean water filter
fits into the machine.
Place back the rubber ring on the
AquaClean water filter.
If the machine starts to make a different
kind of noise, clean the brew group and
lubricate it (see 'Lubricating the brew
group').
Remove the AquaClean water filter from
the water tank and properly prepare it
for use before you place it back. See
chapter 'AquaClean water filter' for
step-by-step instructions.
Make sure the water tank is in the
correct position: remove it and insert it
again pushing it as far as possible.
English
23