LENCO PDR-040 Bedienungsanleitung Seite 23

10. How to use the Bluetooth speaker
10.1. Selecting BT mode
10.1.1. short Press the " /MODE" button to power on the device and
short press the " /MODE" button repeatedly to select BT mode.
10.1.2. The device will automatically find and pair the last paired device
within 5 seconds, if this device cannot find any paired devices, it
will automatically enter search mode 5 seconds later. The display
shows: <BT searching: >
10.2. Connecting Bluetooth devices
10.2.1. Now enable the Bluetooth function on your mobile device and
search for new Bluetooth devices. Select the device named
"Lenco PDR-040".
Wait for a few seconds and you will see the connected message your
mobile device. (For some Bluetooth devices, you may need to input
"0000" as pairing password)
- Display shows: < BT connected > and < Time >.
Note: Set the external device's volume to maximum, then use the volume
dial on the Lenco PDR-040 as main volume.
10.3. Music play
When you are playing music,
10.3.1. Rotate the "Rotary button (07)" to adjust the desired volume
level.
10.3.2. Press the "Rotary button (07)" to pause play.
10.3.3. Press the "Rotary button (07)" again to resume playing.
10.3.4. Press the"
10.3.5. Press the"
10.4. Auto-Re-connect with Paired devices and new Paring
10.4.1. Short press the " /MODE" button to power on the device, short
press the " /MODE"button repeatedly to select BT mode.
10.4.2. It will firstly search for the mobile device which has been paired
previously. The Lenco PDR-040 will re-connect the last connected
mobile device as priority if that one is in Bluetooth search mode.
10.4.3. When no previously paired devices are found, the Lenco PDR-040
will switch to pairing mode.
10.4.4. Now you can process for new mobile device pair. (refer to10. 2)
(03) " button to go to the previous music track.
(04) "button to go to the next music track.
23