Various Sawing Processes; One-Step.sawing; Two-Step.sawing; Safety - Diamond3 Radia 4050TS Bedienungsanleitung

DIAMOND 3
7. VARIOUS SAWING
PROCESSES

One-step.sawing

(Use only original saw blades as advised
by the manufacturer)
• Move saw head down until the saw is
approximately 10 mm below the saw
table .
• Secure saw head with the knob .
• Place the material to be cut on the
sawing table and position against the
fixed stop and eventually the adjust-
able stop .
• Hold the material with two hands while
making sure your hands are free from
the sawing blade .
• Push the sawing table forward with
controlled feed so that the sawing
blade is easy cutting through the mate-
rial .

Two-step.sawing

• Adjust the saw head in its top position .
• Place the material to be cut on the
sawing table and position against the
fixed stop and eventually the adjust-
able stop .
• Hold the material with two hands while
making sure your hands are free from
the sawing blade .
• Push the sawing table forward with
controlled feed so that the sawing
blade is easy cutting through the mate-
rial and move the sawing table back-
ward in its initial position .
• Rotate the material and cut it through
completely .
®
4050TS-4060TS

8. SAFETY

Besides the valid safety regulations atten-
tion to the following items should be made:
• Carefully follow the directions of set-
ting up and working with the sawing
machine .
• Carefully check that the electrical con-
nections are correct .
• Electrical cables should not come in
contact with water or water spray .
• Damaged saw blades should be
replaced immediately .
• Secure material to be cut by hand dur-
ing sawing .
• Make sure your hands stay away as
far as possible from the rotating saw
blade .
• Wear protective goggles during saw-
ing .
• Wear hearing protection during saw-
ing .
15
GB