Various Sawing Processes; Safety - Diamond3 3510 Bedienungsanleitung

GB

7.VARIOUS SAWING PROCESSES

One-step sawing
(Use only original saw blades as advised by the
manufacturer)
Move saw head down until the saw is
appro. 10 mm. below the saw table.
Secure saw head with the knob.
Place the material to be cut on the sawing
table and position against the fixed stop and
eventually the adjustable stop.
Hold material to be cut with one hand while
making sure your hand is not to close to the
saw blade.
Pull the saw head with medium force with
the other hand through the material.
Multiple-step sawing
During this sawing process the saw is posi-
tioned at the desired height and moved back
and forth through the material to be cut until
after a number of steps it is completely cut
through.
Place the material to be cut on the sawing
table and position against the fixed stop and
eventually the adjustable stop.
Position the saw head at the desired height
Hold material to be cut with one hand while
making sure your hand is not to close to the
saw blade.
Switch the machine on and pull the saw
head with medium force with the other hand
through the material.
OPERATING MANUAL

8.SAFETY

In addition to the valid safety regulations atten-
tion to the following items should be made:
Carefully follow the directions of setting up
and working with the sawing machine.
Carefully check that the electrical connec-
tions are correct.
Electrical cables should not come in contact
with water or water spray.
Damaged saw blades should be replaced
immediately.
Secure material to be cut by hand during
sawing.
Make sure your hands stay away as far as
possible from the rotating saw blade.
Wear protective goggles during
sawing.
Wear hearing protection during
sawing.
20