Connecting To Power Supply; Motor Protection; Installing The Saw Blade - Diamond3 Radia 4050TS Bedienungsanleitung

DIAMOND 3
GB
Connecting.to.power.supply
First, check whether:
• the line voltage corresponds with the
data on the machineís specifications
plate,
• there is a grounded power supply,
• the extension cord wire cross-section is
at least ,5 mm 
Motor.protection
The motor is equipped with a thermal
safety switch for protection against an
overload . When the motor gets over-
heated, the switch falls back into its initial
position and can only be switched on
again after the motor is cooled down . The
switch also protects against power failure .
When the power returns, the motor will not
start on its own but must be switched on
by hand .
.
®
4050TS-4060TS
Installing.the.saw.blade
WARNING!
Make sure to disconnect the
machine from the power supply
before fitting or switching the
saw blade or when doing any
maintenance on the machine.
• Remove saw
cover .
• Block the saw-
ing spindle with
the 6 mm Allen
wrench .
• Unscrew the
30 mm hexagon
nut with the wrench and remove the
saw flange .
• Clean the saw flanges .
• Fit the saw blade on the centre ring of
the motor flange . (Check the direction
of rotation and make sure the blade is
well centered.)
• Mount saw flange and tighten with
the hexagon nut . Place saw cover and
tighten with the  knobs .
14