Maintenance; Declaration Of Conformity - Diamond3 Radia 4050TS Bedienungsanleitung

DIAMOND 3
GB

9. MAINTENANCE

• The cooling water should be replaced
and/or replenished regularly .
• It is recommended to clean the water
container, pump, hoses and spray noz-
zle on a regular basis . For example,
place the pomp in a bucket of clean
water after the sawing job and run the
machine for a minute or so . This also
guarantees a longer lifetime of the
pump .
• When the machine is not used for a
longer period, the pump should not
remain in the muddy cooling water .
Cleaning the pump as described
above and leaving it outside the water
container is better .
• Regularly check the V-belts for wearing
and tension . If necessary replace worn
belts .
ATTENTION!
Always replace belts in sets.
• Regularly check the saw flanges for
wearing out and replace if necessary .
®
4050TS-4060TS
10. DECLARATION OF
CONFORMITY
We declare under our sole responsibility
that this product is in conformity with the
following standards or standardization
documents .
98/39/EEC, 91/368/EEC,
93/44/EEC, 93/68/EEC,
89/336/EEC, 9/31/EEC,
73/3/EEC
09
TSG b .v .
R .W . van den Boogaart
16