Connecting To Asc In Client Mode; Overview Of The User Interface - Waeco ASC G Bedienungsanleitung

ASC G Wi-Fi kit
4. If your device is connected to the ASC:
Open a browser and enter the IP address shown on the ASC's dis-
play in the URL field of the browser:
✔ The user interface is shown in the browser.
5. If you connected for the first time to ASC set a bookmark to remem-
ber the IP address of the user interface.
6.1.2

Connecting to ASC in Client Mode

1. Ensure that the „airplane mode" on your device is disabled.
2. Be sure Wi-Fi is enabled on your device.
3. Connect your device to the same network as the ASC.
4. If your device is connected to the ASC:
Open a browser and enter the IP address shown on the ASC's dis-
play in the URL field of the browser:
✔ The user interface is shown in the browser.
5. If you connected for the first time to ASC set a bookmark to remem-
ber the IP address of the user interface.
6.2

Overview of the user interface

You can access the functions by pressing the corresponding button of the
menu bar.
On a PC the menu bar is placed on the upper right corner.
On a tablet and on a cell phone the menu bar is placed at the bottom.
Icon Command
Sensors
Send task
Task history
Maintenance
counters
Unit info
EN
Function
Shows the ASC's current operating values.
Creates a task and sends it to the ASC (chapter
"Creating a task and processing it in the ASC" on
page 10).
Shows all finished tasks.
Shows the ASC's current meter readings and the
total meter readings since the unit was produced.
Shows the data of the ASC.
Access to Wi-Fi setup.
Operating
9