Pando PHB-961 Bedienungsanleitung Seite 85

INOXPAN S.L.
3. Turn the control dial to the
4. 4. You will hear a beep indicating that the SCS cycle has started. The
and the time remaining to complete the cycle will appear on the display.
The duration time is preset to 24 minutes.
The duration of this cycle cannot be changed. To stop the cycle before it is finished, turn the
control dial to the
5. When the cycle is finished, the oven will turn itself off, an alarm will sound and the
flash quickly .
Do not open the oven door until the SCS function is complete.
The cooling cycle is necessary for the function to work properly.
6. Touch any sensor with your fingertip to stop the alarm and turn off the
7. Turn the control dial to the
8. Any traces of dirt and excess water can now be removed from the oven with the damp cloth.
The SCS function takes place at a low temperature. However, cooling times can vary depending
on the room temperature.
Before touching the inside surface of the oven, make sure that it has cooled properly.
If a deeper clean is required after using the SCS function, use neutral detergents and non-
abrasive sponges.
position and press
position.
position.
EN - 15
symbol will flash slowly
symbol will
symbol.